In this hole goes the pump basin, a large heavy-duty plastic “bucket” in which the pump will sit. Then the slab material is removed, and a hole is dug about three feet deep and 2 feet wide. In order to install one of these systems, the first step is to determine the location for the pump based on the fixtures it will service (toilets, sinks, etc.). To accomplish this, it is necessary to install a sewage ejector pump system.Īn ejector pump system is made up of several components the pump basin, the pump itself, and the discharge and vent lines. It is now necessary somehow transfer the waste water generated by use of the new bathroom approximately ten feet overhead to the sewer lines. Due to this arrangement, gravity drainage, which is standard draining operation, will not work. Homes built on a basement typically have the sewer pipes run along the ceiling of the basement, locating them HIGHER than the potential bathroom. When adding a bathroom in a basement, it is crucial to consider the location of the sewer piping in the area. Installing a bathroom only makes sense to complete the transformation.Īdding a bathroom in a basement requires some additional planning however, and some extra work and prior thought is necessary to ensure proper operation of the new facilities. When finishing a basement, it often ends up like an entire other home, featuring bedrooms, a kitchen, and living spaces. In the sewage grinder pump photo shown at above left, the number of wires and pipes at the tank tells us that this is a duplexed or two-pump system with two grinder pumps, two drains, and a tank alarm as well (the center wires).īasement additions are becoming more and more popular as homeowners make the decision to finish and transform this otherwise dull area of the home, facilitating the need for another bathroom. Sewage or blackwater to a destination such as an elevated septic tank or to a city sewer (for homes whose lower baths are at a depth below the level of their sewer line).Įven if a building is nearly at the same level as its septic tank or sewer line, if the geography of the site prevents sewage from flowing fast enough on its own (two-feet per second) then a sewage grinder or sewage ejector pump is needed.Ī sewage or septic grinder pump, (there is more than one grinding method) reduces sewage to a finely ground slurry of waste and water which can then be pumped or forced to its destination.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |